This Checklist is provided courtesy of Chuck, please reference the full guide at Chuck's Guides

Startup

1. Select Flight Engineer by pressing “3” and turn on all circuit breakers by clicking handles.

2. Turn off Anti-Ice system breakers if you are flying in a hot day (above 0 deg C). Tip: these breakers are to the right of the two breakers that are OFF by default.

3. Optional - Make sure that all switches are OFF.

4. Set Hydraulic switch to MAIN (UP), Fuel Crossfeed valve ON (UP) and Fuel Bypass OFF (DOWN).

5. Set Fuel Content Selector to “Total” and check fuel quantity.

6. Collective full DOWN, Throttle FULL LEFT (CLOSED), Condition Levers MIDDLE

7. Battery #1 & 2 – ON (UP). STBY Gen – OFF (DOWN)

8. DC selector knob – BATTERY BUS

9. 36V Instrument Transformer – MAIN (UP)

10. 115V Inverter – MANUAL (UP)

11. Set radio to AM, R-863 (УКР/UHF) and RADIO and desired frequency (tower).

12. Fire Protection Switch – FIRE EXTING. (UP)

13. Service Fuel Pump ON

14. LEFT & RIGHT Fuel Shutoff Valves – ON
• Note: Flip red cover switch

15. Pitot Heat – ON/UP (as required)

16. APU Mode Switch – START (UP)

17. Press APU START switch (2-3 sec). Make sure EGT, Air and Oil Pressure are rising within 9 seconds. Wait until APU has stabilized (1 min approx.)

18. Select Left Engine (or downwind engine first) and select “START” (UP) starting mode.

19. Release Rotor Brake (DOWN position)

20. Press “START” button for 2 to 3 seconds to initiate start sequence.

21. Click on left/selected engine red fuel shutoff lever (“Engine Stop”) to push it forward . RPM should begin to rise.

22. Once Engine #1 reaches a N1 RPM of 60-65%, wait 1 minute for APU to cool down (optional) and select right engine.

23. Press “START” button for 2 to 3 seconds to initiate start sequence of second engine.

24. Click on right engine red fuel shutoff lever (“Engine Stop”) to push it forward. RPM should begin to rise.

25. Once Engine #2 reaches a N1 RPM of 60-65%, wait 1 minute for APU to cool down and stabilize.

26. Left & Right Fuel Pumps – ON (UP)

27. Throttle FULL RIGHT (max throttle)

28. Generators #1 & #2 – ON (UP)

29. Rectifiers #1, #2 & #3 – ON (UP)

30. 36V & 115V inverters – AUTO (DOWN)

31. Press APU OFF button

32. Left Attitude Indicator – ON (UP)

33. Gyro Cut-Out Switch – ON (UP)

34. Pitch Limiting System – ON (UP)

35. Doppler System switches – ON (UP) and OPERATE (РАБОТА) (behind co-pilot seat)

36. YaDRO-1A radio – ON (UP)

37. Gyrocompass System – ON (UP)

38. Right Attitude Indicator – ON (UP)

39. Blade Tip Lights – ON (UP)

40. Strobe Lights – ON (UP)

41. Pitch & Roll Autopilot Switch – ON

42. Radar Altimeter – ON (UP)

43. Once Radar Altimeter Test is complete (30sec approx.), rotate (mousewheel scroll)yellow knob until radar altimeter warning light is reset.

44. Accelerometer – RESET

45. Close Side Blister Windows
• Left : LCtrl+C • Right: LShift+C

46. Release Wheel Brake lever (binding: “W”)


Please enter typos and erros in this checklist here
Please enter recommendations and ideas for this checklist here