Take Off By using the HUD

1. Apply brakes

N/A

2. Advance throttle to maximum power without afterburner.

Check EGT (max 590°C + outside ambient temperature)

3. Release brakes, steer with pedals

N/A

4. If needed, ignite afterburner.

Check-
a. Zone indicator = desired afterburner zone.
b. Exhaust nozzle indicator = desired zone achieved.
c. Pressure ratio (EPR)-
-Zone 2
---» < +15°C > 1.9
---» > +15°C > 1.8
-Zone 3 = Maximum power

5. Check airspeed indicator and Time / distance line

N/A

6. Rotate with the flight path vector when the time / distance line reaches the markers.

Set flight path vector to;
a. The horizon line when not using the after burner
b. To about the height of the outer pillars (about 3° above the horizon) when using the afterburner.

7. Check the increased airspeed on the airspeed indicator.

N/A

8. Retract the landing gear when airborne.

N/A

Note the risk of a decrease in lift as the flaps retract when retracting the landing gear

N/A

9. Climb with selected attitude until the flight path vector appears. The HUD should switch modes automatically between the take-off symbology and the normal navigation mode.

N/A

10. Elevate HUD reflector glass to inflight mode to display HUD symbology when at lower angles of attack.

N/A

Please enter typos and erros in this checklist here
Please enter recommendations and ideas for this checklist here